MAINTENANCE-FREE, VALVE-REGULATED,
SEALED LEAD ACID BATTERIES.
DESIGNED FOR DEEP CYCLE 50% DISCHARGE RUGGED USE.
SOLAR ENERGY or PHOTOVOLTAIC APPLICATIONS - HYDROELECTRIC APPLICATIONS - WIND ENERGY APPLICATIONS
All PRICES INCLUDE SHIPPING/DELIVERY TO CONTINENTAL U.S.
Standard Terminals: All batteries with a "T" in the part number now incorporate copper alloy M8 terminals except the PVX-340T & PVX-420T which are M6. All batteries supplied with silicon bronze bolts, nuts, and washers as required for installation. Torque Value M6: 35 in-lbs / 4.0 nm. Torque Value M8: 70 in-lbs / 7.9 nm.
Optional Terminals: L Blade or Automotive post type terminals are available installed by adding the appropriate suffix: "L" for L Blade or "A" for automotive post. Handles: All part numbers include lifting handles except the PVX-490T, PVX-560T, and PVX-2240T. Ratings: Capacity ratings are stated at 77F (25 C) to 1.75 volts per cell. Drawings: Click on the part number in the table above or contact the factory.
Solar Batteries have No exposed lead terminals. This change was made to improve environmental safety and health. Sun Xtender reacted positively to the predominant indoor residential, commercial, and industrial solar installation of their products.
Solar Batteries are UL listed. Approved by Building Inspectors. This coveted mark, and subsequent testing of these solar batteries was done by the manufacturer to ease customer`s ability to install their products. Now UL approved paperwork is available from both the manufacturer, and this website. UL Battery Documentation - UL Listed Batteries BR>
SUN-XTENDER® BATTERY DESIGN FEATURES
Copper Alloy Terminals for improved electrical connections.
No exposed lead terminals. This change was incorporated to improve environmental safety and health.
Threaded insert terminals are recessed to prevent short circuits across battery connections.1
New cover is flat top design. No protruding or exposed vent valves.1
Built in lifting handles, except PVX-490T, PVX-560T, and PVX-2240T.
Reinforced container walls to reduce bulging.
High Impact Strength Copolymer Polypropylene Case and Cover.
Completely Sealed Valve Regulated Construction.
Immobilized Electrolyte Non-Spillable.
Maintenance Free Design Never Requires Watering.
Absorbed Glass Mat (AGM) Micro-porous Glass Separators retain electrolyte.
Flame Arresting Pressure Regulated Safety Valves.
UL Recognized Systems Component.
Positive Plates - Proprietary Lead Calcium Alloy- Negatives Plates - Lead Calcium.
Low Self Discharge Rate Approximately 1 % per month at 25 C (77 F).
Operate over a Wide Range of Temperatures from -40 C (-40 F) to +72 C (+160 F).
Classified as "Non-Spillable Battery" for transport. Complies with DOT HMR49, Non-Hazardous Materials.
1 Threaded Insert "T" type Features.
SOLAR BATTERY CHARGING INSTRUCTIONS
Initial charge or recharge: 2.37 to 2.40 volts per cell at 25 C (77 F).
Float charge: 2.20 to 2.22 volts per cell at 25 C (77 F).
Equalize charge: 2.40 volts per cell at 25 C (77 F)*.
Temperature compensation = ±3.75 mV. per cell per degree C [Reference to 25 C (77 F)].
This is for battery temperature (not ambient temperature) and is useful for battery temperatures from 0° C (32° F) to 40° C (104° F).
Contact Concorde Battery Corporation for battery temperatures that exceed this range. *AGM Batteries are sealed by the manufacturer. These solar batteries are UL approved because of this seal. However, this design prevents the addition of water to your solar battery. An equalize charge is a deliberate boiling of the electrolyte under an overcharge condition to "FORCE" power back into the system. Although this may recover elder solar batteries, it may also run them out of electrolyte, rendering your bank of solar batteries useless. The manufacturer reccommends you equalize your batteries only 2 times over their lifespan.
BD Batteries - A Broomfield-Designers Company
Serving the Local Colorado Community 9-5 Mountain & Emergencies P. 303-800-4725 F. 303-600-9726
Serving the Buffalo and the Great Lakes Communities 9-5 Eastern & Emergencies P. 716-531-4875
Mailing Address: 5023 West 120th Ave. #138, Broomfield, CO 80020
OUR DENVER WAREHOUSE IS MOVING TO A NEW LOCATION AT THIS TIME.
WE WERE SCHEDULED TO REOPEN OUR BRICK AND MORTAR BATTERY WAREHOUSE IN EARLY 2011.
IN THE MEAN TIME OUR WEBSITE AND PHONES OPERATE FINE!
We do thank the public for the outreach of concern, and votes of confidence.
Do call Lorene prior to schedule used battery pickups, new battery dropoffs, etc. by appointment.
The information contain on this deep cycle AGM batteries website is deemed reliable, but not guaranteed. Please verify specific information on marine AGM batteries, rv AGM batteries or auto AGM batteries listed here by calling us direct. We are proud to offer the highest quality AGM batteries and hope you will consider using our deep cycle AGM batteries in the near future!
SUN-XTENDER® BATTERY DESIGN FEATURES
Initial charge or recharge: 2.37 to 2.40 volts per cell at 25 C (77 F).
